Softrim Recommended Settings
From Derek's written procedure:
Start Up:
Once the machine is plugged into 110v 15amp standard outlet the HMI will start up then press the “Start” program. When pressed the PRI software will appear, press continue, and you will be brought to the Softrim home page.
Prior to starting the machine, please ensure that all doors are close and all connectors are connected to their proper receivers (2 Cartridge connectors and 2 connectors going from the machine to the HMI), ensure the E-stop is disengaged (If engaged rotate to the right) and press the blue light if its solid you are ready to begin processing, if it still flashes
HMI Blue light indicators
Slow flashes- Just press the blue button and it will be solid
Fast Flashes- Indicates there is a fault, ensure all doors are closed and all connectors are connected properly. Then press the green button and if all the connectors are correct, and doors are closed it will be solid once pressed.
Solid- Ready to Run
Main Machine:
Primary Belt: Fully adjustable (Ideal settings to start are 75-100 speed)
Draw Belt: Do not go above a speed of 25 (Ideal settings to start are 1-5 on STITCH(Constant for Smalls))
Oscillator: Start at 0 and activate if necessary (if using start at 5 and increase in increments of 5)
Spacing: Fully adjustable (Idea spacing to start is 4-5 (3-3.5 for Smalls) and tighten as needed)
Vibratory Conveyor
Controller: Do not go above 65 speed (Default will be set at 65).
To adjust speed settings press the corresponding arrows.